Introduction

Follow this guide to replace a dead or worn-out battery in your Lenovo ThinkPad T16 Gen 3 laptop.

The Lenovo model number for the battery is L23M4P70 for the 52.5Wh model and L23M4P71 or L23M4P72 for the 86Wh model.

  1. xxNOPMoGoWYkTGQE
    xxNOPMoGoWYkTGQE
    GUnBXysNB2NxAUKS
    YNC2EdVroQAhUjPC
    • For your safety, discharge your battery below 25% before disassembling your laptop. A charged battery may catch fire if damaged. If your battery is swollen, take appropriate precautions.

    • Completely shut down your laptop (don't just put it in sleep mode) and disconnect all cables.

    • Flip the laptop upside-down, and rotate it so the screen hinge faces towards you.

  2. RbWgoD2uaUqYYHy2
    RbWgoD2uaUqYYHy2
    3yXt1uueHCgFQBV2
    • Use a Phillips screwdriver to fully loosen the seven captive screws securing the base cover.

  3. xyP2CA2xDRghTaRR
    xyP2CA2xDRghTaRR
    BIgZKvTMkNb2MBQK
    ahNyGAEmIWqnirIT
    • Insert your fingernail or an opening pick into the gap between the base cover and keyboard deck, next to one of the screen hinges.

    • Pry up the base cover until the clips unfasten.

  4. rQiUEKGPLWPWJRrm
    rQiUEKGPLWPWJRrm
    cb5tJFXBhvJPoSPQ
    • Grasp the base cover along the screen hinge edge and lift slowly to unfasten the remaining clips.

    • Lift and remove the base cover.

    • During reassembly, lay the base cover into the frame, inserting it into the tabs along the battery edge. Press down firmly around the perimeter to reengage all the clips.

  5. tkYPg2EhajlcGZG6
    tkYPg2EhajlcGZG6
    kewyINYhKrkeCqNM
    • Because of the battery connector's design, the only way to disconnect the battery is by physically removing it.

    • Use a Phillips screwdriver to fully loosen the two captive screws securing the battery connector.

  6. VbFsBodaaINR1abt
    VbFsBodaaINR1abt
    OBXrUehAO2CM5QdQ
    YXbYLqdNKDUOLNDm
    • Lift the edge of the battery with the connector to disconnect it.

    • You may feel a little resistance from the battery connector as it disconnects—that's normal.

    • Remove the battery

    • During reassembly:

    • Slide the plastic tabs on the long edge of the battery into their recesses in the frame.

    • Lower the battery into place so the connector goes over its socket.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Calibrate your newly installed battery after completing this guide.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Nick Schultz

Member since: 24/03/24

13497 Reputation

0 comments