Sonos One Protective Cover Replacement

Written By: Marcus Glowa
  • Comments: 3
Sonos One Protective Cover Replacement

Difficulty

Easy

Steps

5

Time Required

2 minutes

Introduction

This guide is for the replacement of the metal housing for the Sonos One.

Important: Accessing the internals of the Sonos One will void the factory warranty and make the unit rejected for factory repair, even if warranty is expired.

  1. usaBbBDLJNDfWMdm
    usaBbBDLJNDfWMdm
    FZK3GRjl32PXic3a
    y1YasRcElZVao6pC

    • Disconnect all power cords.

    • Remove the rubber foot and plastic screw guard on the bottom of the device using a plastic opening tool.

    • Note: the rubber foot and plastic screw guard can be removed as one piece to make reassembly easier

  2. 4EkQjavLKByFVJVE
    4EkQjavLKByFVJVE
    Wc1uefX2jiRMYr1H
    DXykovl1MOrqFTqe

    • Remove the four 10mm Torx T10 screws from the bottom of the speaker.

    More specifics on the four 10mm Torx T10 screws at the bottom, step 2.

    ex: M3

    Thanks

    J Pappas -

  3. MRXUMkYRPc26bSqp
    MRXUMkYRPc26bSqp
    s4HJvieC1YruHify

    • Remove the bottom cover by squeezing the protective cover slightly while pushing up with your fingers.

  4. FbUStLbNAKGaxOWg
    FbUStLbNAKGaxOWg
    Uaq4wNCVYhPPCrxg
    HB36AKuFlDDSmAMt

    • The protective cover clip is very thin and deforms easily.

    • Remove the single 8mm Torx T10 screw and protective cover clip.

  5. 1DHmTOL1GUkrko1U
    1DHmTOL1GUkrko1U
    mbw2scALRUrUHfCY

    • Slide the protective cover upwards to remove.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Marcus Glowa

Member since: 14/02/18

1046 Reputation

2 comments

Well done! I would add a little bit about how much adhesive there is underneath the rubber feet as well as the screw cover.

Joshua Pinter -

Thanks for the helpful instructions! Could you let me know where I can order the protective case?

Nick Geleedst -