Shark UltraCyclone CH951 U4 Casing Replacement

Written By: Samuel Seitz
  • Comments: 0
Shark UltraCyclone CH951 U4 Casing Replacement

Difficulty

Moderate

Steps

6

Time Required

5 - 10 minutes

Introduction

This guide will provide instruction for how to safely remove the plastic outer shell of the Shark UltraCyclone CH951 vacuum. The black casing that covers the majority of the exterior of the Shark UltraCyclone is removable. It's required to remove this casing in order to replace many of the components that protected by it. The casing is resistant to being removed so this is a moderately difficult task.

Note: If there are exposed wires or any defects noticeable, proceed with caution as other issues may cause risk.

  1. xIONpYyrKTupWvgi
    xIONpYyrKTupWvgi
    GPvdThj1wBe5JlEW
    MxWfqtthD1dwILPD

    • Press the dust cup release button and gently pull the dust cup away from the body of the vacuum.

  2. cF3trWP1OF3bo1Nr
    cF3trWP1OF3bo1Nr
    FNWB1QrGLBTB2gGp

    • Use a TR9 Torx screwdriver to remove the two 8.7 mm screws previously behind the dust cup.

  3. Ks4Mfwv5FTQvTNUi

    • Remove the two 12.2 mm screws underneath the dust cup button using a TR9 Torx screwdriver.

  4. mSVIUPN6GXRQxOpF

    • Remove the 13.9 mm screw beneath the charging port using a TR9 Torx screwdriver.

  5. cGocnxAWtmjNyWtR

    • Use the TR9 Torx screwdriver to remove two 11.6 mm screws that hold the exterior motor in place.

    • They are located underneath where the dust cup previously was and above the exterior motor.

  6. VsxXKbF3WZUQ636U
    VsxXKbF3WZUQ636U
    YRbbQ56Wg4tKWvEB
    64RpJneILdZ4x4w6

    • Run an iFixit Opening Tool under the casing along the vacuum body until the shell is removed starting around the attachment port, and sliding down towards the charging port.

    • If necessary, apply gentle force.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Samuel Seitz

Member since: 24/01/25

172 Reputation

0 comments