Shark Rocket HV322 Motorized Floor Nozzle Cover Replacement

Written By: Sam Ehrenzweig
  • Comments: 0
Shark Rocket HV322 Motorized Floor Nozzle Cover Replacement

Difficulty

Moderate

Steps

3

Time Required

5 - 10 minutes

Introduction

Use this guide to replace the motorized floor nozzle cover on a Shark Rocket HV322 if the motorized floor nozzle cover is damaged or needs to be removed to access components underneath it.

The motorized floor nozzle cover protects key components of the motorized floor nozzle like the brushroll motor and circuit board.

Be sure to turn off and unplug the vacuum before beginning.

  1. CYRZIpxvMjVKJa1L
    CYRZIpxvMjVKJa1L
    ETw1AYJdIQkJoPN6

    • Make sure vacuum is turned off and unplugged before starting.

    • Push down on the black wand release lever to remove the motorized floor nozzle.

  2. msMZsZhVq3xtpLXg
    msMZsZhVq3xtpLXg
    drnqnsOjpAjIAaQO
    fpytitLwddDNLWJd

    • Rotate the three locks that secure the brushroll cover with a spudger.

    • Remove the brushroll cover.

    • The locks will click when they have reached the "unlock" position.

  3. fBBrSsUAm5yUKLPW
    fBBrSsUAm5yUKLPW
    NQVaSYfmb3iITQrJ
    vpgrSYb4GiVFk6TG

    • Remove the ten 9.4 mm Torx T8 screws on the bottom side of the motorized floor nozzle.

    • Remove the brushroll cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sam Ehrenzweig

Member since: 26/03/25

305 Reputation

0 comments