SONY MVC-FD200 Battery Replacement

Written By: Kobe Rodriguez
  • Comments: 0
SONY MVC-FD200 Battery Replacement

Difficulty

Very easy

Steps

2

Time Required

30 seconds

Introduction

This guide will show you how to replace the battery in a SONY MVC-FD200 camera. Whether you have a faulty battery, or would simply like to carry around a few extra for an extended outing, this guide will show you how to switch them out. Before you begin, make sure to turn off the camera.

  1. 4igXGUWvbFOccWVg

    • Using your finger, slide the tab on the battery door up to release the battery latch.

  2. ZCsjOxpy1QXX1ABH

    • Lift the battery door to reveal the battery compartment.

    • Push the gray lever to the left side to remove the battery.

    • If any other repairs are needed, make sure to carefully remove the battery to avoid any electric shock or short circuits during repairs.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Kobe Rodriguez

Member since: 21/03/25

366 Reputation

0 comments