Ozeino OW810 Microphone Replacement

Written By: Rylee
  • Comments: 2
Ozeino OW810 Microphone Replacement

Difficulty

Moderate

Steps

4

Time Required

No estimate

Introduction

If your Ozeino OW810 isn't properly transmitting your audio through the microphone use this guide to replace the microphone. The microphone is usually attached to a stand or mount that could be a threaded screw connection at the base of the mic. Before using the guide, examine the Ozeino OW810 and attempt disconnecting and powering it off. These steps require you to take apart the microphone.

  1. TZLljCWL5PLGDYb1

    • Step 1:

    • - Ensure the Ozeino OW810 headset is powered off and disconnected from any device.

    • -Remove any external accessories if any.

    • Take The Marlin Screwdriver set and use the Philips screwdriver

    Specify which type of Phillips screwdriver to use.

    Estella salazar -

  2. EHSPZvQxvgenyuLe

    • Step 2

    • -Look for the screws holding the microphone together, usually located on the side or bottom of the microphone.

    • -Use the Philips Flat head screwdriver

    • - Remove the two 3.175 mm Philips screwdriver #1

  3. sYAMCMlxWFdlP4xy

    • Step 3

    • -Look for screws or clips that are holding the microphone in place

    • -Remove carefully

  4. TTSc3jOkYHFk3UaE

    • Step 4

    • - Take out wires

    • -Use the Opening pick to pry it open

    • -Be gentle with the wires and connectors

    • -Avoid damaging them

    Add how to replace the microphone part, not just how to open the microphone.

    Estella salazar -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Rylee

Member since: 19/02/25

571 Reputation

0 comments