Microsoft Surface Pro 11 SSD Replacement

Written By: Spencer Day

Comments: 0

Microsoft Surface Pro 11 SSD Replacement

Difficulty

Moderate

Steps

Time Required

5 minutes

Introduction

Follow this guide to replace or upgrade the SSD in your Microsoft Surface Pro 11.

Before starting this repair, read through Microsoft's guide on best practices for SSD removal. If your replacement SSD has data on it, make a backup of the drive before installing it.

Tools

Step 1

Before starting this repair, allow your laptop's battery to drain below 25%. A charged battery may catch fire if damaged.
Unplug all cables and fully shut down your laptop.

Step 2

Lay your Surface Pro screen side down and open the kickstand to about a 90‑degree angle.

Step 3

Use your finger to firmly press down on the SSD door indent until the door pops up.
Remove the SSD door.

Step 4

Use a Torx Plus 3IP screwdriver to remove the 2.4 mm‑long screw securing the SSD.
Removing the SSD also functions as a battery disconnect and should be done before all major repairs.

Step 5

Don't pull up at a sharp angle, or you may damage the SSD and its socket.
Use the flat end of a spudger to gently lift the notched edge of the SSD enough that you can grip the bottom corners with your fingers.
Use your fingers or tweezers to pull the SSD straight out of its socket and remove it.
During reassembly, getting the SSD fully inserted in its socket can be tricky. If you're having trouble, hold the SSD in place and use the flat end of a spudger to push on the notched edge.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Once your laptop is reassembled, follow Microsoft's post SSD replacement guide.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Author

Spencer Day

Member since: 14/09/22

117606 Reputation