Insignia 6-Quart Pressure Cooker Float Valve Replacement

Written By: Savannah Webb
  • Comments: 4
Insignia 6-Quart Pressure Cooker Float Valve Replacement

Difficulty

Easy

Steps

3

Time Required

2 minutes

Introduction

Float valves may wear out over time, preventing them from rising or falling correctly. This guide will demonstrate how to replace the float valve.

  1. sMg1gImc6vCLltGR

    • Remove the lid and place it upside-down on a flat surface.

  2. cQ5ieUWJBKWxoKSO

    • Pinch the rubber gasket on the float valve and pull up.

  3. YZZMBtU5ANEDA1AK
    YZZMBtU5ANEDA1AK
    EQbLPMW6SAFyRxA6

    • Pull the rubber gasket off of the metal rod.

    • The valve will fall out of its hole onto the table. It can now be cleaned or replaced.

    • You may find it helpful to push up on the float valve from the other side of the lid while you remove the gasket.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Savannah Webb

Member since: 19/01/18

657 Reputation

4 comments

I received the replacement valve and pot. Now my insignia instapot won't hold pressure. It keeps seeping steam/spritz out of the float valve. I am ready to toss it in the trash. It worked bafore I replaced that stem. I should've kept it.

Carole Neider -

It happened to me as well. Right after I replaced it, it doesn’t hold the pressure. I am very annoyed and I wish I have kept the old parts!!!!

Valentina -

OK after much digging, I found the old valve and now it is pressurizing.

Carole Neider -

where can I buy the float valves

valuacion.urbanismo -