Google Pixel 9a Rear Cover Inner Adhesive Application

Written By: Spencer Day
  • Comments: 0
Google Pixel 9a Rear Cover Inner Adhesive Application

Difficulty

Moderate

Steps

4

Time Required

No estimate

Introduction

This guide shows how to apply the rear cover inner adhesive for your Google Pixel 9a smartphone.

  1. CStPTSRXHX1sUqWc
    CStPTSRXHX1sUqWc
    jnMGY6kuOFMelRH3

    • Use the flat end of a spudger to scrape up and remove any all the old adhesive that stayed on the back cover, including the five pieces of small, oval‑shaped adhesive.

    • If you don't see all the oval adhesives, some might've stuck to the phone frame.

  2. kwYxH2YgaPvmZduK

    • Use high‑concentration (>90%) isopropyl alcohol and a lint‑free cloth (or coffee filter) to clean up and remove any residue from the adhesives you removed.

  3. nN24V1kN2ciBMhtM
    nN24V1kN2ciBMhtM
    iSBuF2EfsGB3I2TG

    • Remove the larger, clear liner from the back cover inner adhesive.

    • Lay the adhesive onto the bottom of the back cover, making sure the cutout goes around the camera bezel.

  4. RSraMRVelln5pNBR
    RSraMRVelln5pNBR
    ZfO2aiJPo3ImqABh

    • Use your fingers or a spudger to firmly push down on the five small adhesives to secure them to the back cover.

    • Slowly peel up and remove the remaining liner.

    • If the adhesives start to peel up with the liner, lay it back down and use your spudger to secure the adhesive again.

Author

Spencer Day

Member since: 14/09/22

117606 Reputation

0 comments