Euhomy IM-06D Fan Replacement

Written By: Joel Mello
  • Comments: 0
Euhomy IM-06D Fan Replacement

Difficulty

Moderate

Steps

5

Time Required

5 - 10 minutes

Introduction

This guide is for the Euhomy IM-06D icemaker. This guides purpose is to replace the fan. This part helps get rid of the heat generated by the machine during the cooling process. Symptoms that mean this part may need to be replaced can be the fan not spinning or making unusual noises when spinning. Please make sure to unplug the device before starting all guides.

  1. RGWRZyEflEUOGEJQ

    • Rotate the device so that the screws on the bottom are visible.

    • Remove the two 15 mm Phillips screws.

    • Remove the two 10 mm Phillips screws.

  2. Y3UZrTJUJEhuHjMB
    Y3UZrTJUJEhuHjMB
    sH1UBSdRFxNu4Piq

    • Remove the back panel from the device.

  3. ZndrJMGWeqELMNQB

    • Remove the two 10 mm Phillips screws that secure the fan.

  4. rHKwTccKPNWXwMYW
    rHKwTccKPNWXwMYW
    H3JqhSbRwpmWvZfT

    • Remove the cover plate.

  5. ZybdEgb3tLQZbQQS
    ZybdEgb3tLQZbQQS
    yU4Sav3yBrSaptrr

    • Snip the zip tie holding the wires together.

    • Unplug the wire from the board.

    • Remove the fan from the device.

Conclusion

To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.

Author

Joel Mello

Member since: 21/03/25

415 Reputation

0 comments