Dell Inspiron 5570 Back Cover Replacement

Written By: Clay Eickemeyer
  • Comments: 3
Dell Inspiron 5570 Back Cover Replacement

Difficulty

Easy

Steps

4

Time Required

10 - 20 minutes

Introduction

Follow this guide to remove and replace the back cover on your Dell Inspiron 5570.

  1. 5yImEDUUjKUJYss2
    5yImEDUUjKUJYss2
    YVcxjdYT5AdWxHGK

    • For your safety, discharge the battery below 25% and power down your device before disassembly.

    • Use your Phillips screwdriver to remove the seven screws securing the back cover:

    • Three 5 mm-long screws

    • Four 7.5 mm-long screws

    • Loosen the three captive screws.

  2. OjvWJUL1qMSTsA1E
    OjvWJUL1qMSTsA1E
    wyZYoOWbUo1rFM65

    • Flip the laptop upright and open the lid so that the keyboard is exposed.

    • Insert an opening pick between the front right corner of the back cover and the chassis.

    • Pry upward to release the retaining clips holding the cover.

    • You'll hear clicks whenever a clip is released.

    • Repeat this procedure for the opposite corner.

    Mit Öffnen des Displays startet der Rechner - der muss natürlich sofort wieder heruntergefahren werden vor Öffnen des Gehäuses!

    Frank Hennig -

  3. gWOfGWq3HgK4Keqt
    gWOfGWq3HgK4Keqt
    WpYINlGYCuwSVonl

    • Insert an opening pick between the front edge of the back cover and the chassis, near the trackpad.

    • Pry upward to release the clips along the front edge of the laptop.

  4. HUY2eKZX5stXERKB
    HUY2eKZX5stXERKB
    NKxl4JQPbBAgOLGZ
    WpHaBfgT4oJyJPwR

    • Close the screen to the laptop and flip it over.

    • Pull the left side of the back cover away from the frame and remove it.

    • If your back cover is stuck to the chassis, use an opening pick to release the clips around the back cover's perimeter.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Dell Inspiron answers community for help.

Author

Clay Eickemeyer

Member since: 19/09/22

85514 Reputation

2 comments

Wie kann ich die unverlierbaren Schrauben aus der alten Bodenplatte entfernen und in die neue einbauen?

Andreas Sonka -

Personally I would start loosening the bottom cover while the laptop is upside-down, as the laptop is quite heavy for its size and can make unclipping the clips slightly more difficult.

Tai Lam -