Geek Bar Pulse Teardown

Written By: Greg
Published: 07/06/24
  • Comments: 6

Geek Bar Pulse Teardown

Published: 07/06/24

Teardown

Introduction

How to disassemble Geek Bar disposable vaping unit.

  1. Til1S3fTY2WZScEa

    • Use a wood chisel (~1 inch) along the seam to break loose the clear cover. The cover snaps into place but may be lightly glued.

  2. aZi5dqh5ccCEZ5WG

    • Pull out the internals. You will need to push in the on/off switch at bottom of unit to get the insides to slide out.

  3. xEHN5ZxquImnNkLw

    • Detach tank. Note location of wiring if you are going to reassemble unit.

  4. PVC6uxI6FqLyjOPQ
    PVC6uxI6FqLyjOPQ
    a5iCkZcHxyQuRZIV
    4NKAXBPHkd4jQRTc

    • Pull off top of tank.

    • Pull heater unit out of steel sleeve.

    • Remove flat wick from heater

    • Observe basket style heater unit. Resistance readings: blk-grn: 1.1 ohms; blk-red: 1.1 ohms; red-grn: 2.2 ohms

  5. L2sCXBlGwJ6ZnTES
    L2sCXBlGwJ6ZnTES
    kd3MElTWqQcGyV1D

    • Unsnap the circuit board from the L-shaped plastic holder.

    • View board.

  6. evQiXXN16NMUTPPJ

    • The lip piece can be unsnapped from the inside, pulled out from the top and disassembled as shown.

Author

Greg

Member since: 23/08/20

251 Reputation

6 comments

Perfect illustration and pics.

Leo Arakel -

Hell yeah thank you

zzaqd -

love u man, sooo much

Emran Shafaq -

So satisfying. Now it's a perfect secret-stash container too!

PhoenixEd -

I used this to open it and fix an auto-fire/over-fire I was experiencing. I've had it happen before but simply cannot afford to buy another. After opening, I powered it on, hit it & it hit fine. I then switched it off, put the switch cover back on, hit it and back to auto/over-firing again. I removed the switch cover and it was fine, closed it back up without the switch cover and it hits fine, pulls more air in, but I am thinking based off my understanding of vaping herbs that a faster, higher airflow willl create a lower temp & therefore, it shouldn't use up as much fluid per use even tho I have it set to pulse mode. This won't effect the fluid guage as it's predetermined and even if you add fluid while at say 60%, it will not change the level shown or the amount it displays. I'm used to having them display 0% and having several days of full flavor/hits even after this. Thanks for the breakdown, clean, simple, easy to understand. I've opened the Pulse X but never one like this, so thanks.

EROCK611 -

Thank you so much this is going to help me with one of my projects.

Prince Doge -