Binbok EVO Pro Controller Teardown

Written By: Tim McMahon
Published: 01/09/23
  • Comments: 0

Binbok EVO Pro Controller Teardown

Published: 01/09/23

Teardown

Introduction

Here is a teardown of the Binbok EVO Pro Controller for the Nintendo Switch.

  1. 1WwAO6mSQaeYJUK6
    1WwAO6mSQaeYJUK6
    qheWbJa1Rx5VX2QS
    qlDSYEhUggBpPKbP

    • Use a Phillips #0 screwdriver.

  2. T2nP241lAIi44QNe

    • The cover pulls off without much resistance.

  3. bIsHWb5Q61UDr2Df

    • Peel the battery up carefully. The adhesive is sticky and lifts easily off the PCB. I was a bit worried about being able to put the battery back, but the adhesive is sufficiently sticky to re-install it.

  4. XPnqI2JcgSnKUjhA

    • Four screws are near the middle of the PCB while two screws are hidden away near the motors.

  5. bvwrWfKXGXjPcFSS

    • Insert wisdom here.

  6. qtfLLCLKaGTBwyNW
    qtfLLCLKaGTBwyNW
    QPP5yawLCiEIGViM

    • The covers each have little inserts that can be pulled through with tweezers or pliers when re-installing them.

  7. Ep3xkVmayAtnhsCy

    • Insert wisdom here.

  8. p6H3vcYYWXapFZUa

    • Insert wisdom here.

  9. SCAbeWEudeG5qfbe

    • I put the controller back together and it still works!

Author

Tim McMahon

Member since: 09/11/22

184 Reputation

0 comments