iPhone 4 Rear panel glass Replacement

Written By: joe

Comments: 2

Difficulty

Easy

Steps

Time Required

No estimate

Introduction

Kara, my four-year-old granddaughter repairs Grandma's iPhone.

Tools

P2 Pentalobe Screwdriver iPhone

Step 1

Here you can see the original cracked rear panel and the replacement panel.
Next using a Phillips head screwdriver, remove the mounting screws at the bottom of the iPhone. Place them aside carefully as they are really small.
Finally, once the screws are out gently apply pressure and slide the screen up to release the panel. Careful not to be too rough with it.

Step 2

Carefully place the replacement panel on to the iPhone back lining it up as close to the bottom as possible.
Now again gently apply pressure as you slide the panel towards the bottom of the iPhone to lock it into place.
Replace the screws that you set aside earlier and be sure no to over tighten otherwise you will strip them.

how about replacing the screen?coz i try to remove the screw's it was soo hard to take it off for some reason i have no clue...

recel.hunt - 22/02/17

It's in there pretty good and tight so you need to slide it up to release the screen, just don't be too rough with it as it's still delicate but it will come loose. You may need to work at it a little bit.

Trekboy72 - 11/04/17