Water connection seal replacement

Written By: VauWeh
  • Comments: 2
Water connection seal replacement

Difficulty

Moderate

Steps

3

Time Required

No estimate

Introduction

If the water runs out of the water tank when the tank is installed, then this seal (inner manifold sleeve) must be replaced. The repair is very simple. You do not have to open the coffee machine. If the water runs out of the tank itself, the seal in the tank must be replaced, this is described here.

  1. MBlhfrsDS3SZkJPL

    • Take the water tank off.

    • The seal is held in place only by a cover.

  2. MeUqFoh6dcDQFiNA
    MeUqFoh6dcDQFiNA
    TXXtYGFNS3aUemtM

    • The cover is held in place by two notches below the marked points.

    • Using a plastic opening tool, gently pry the seal cover alternately near the notches until it releases.

    • Remove the cover

  3. OfgEZJSWIwqbtyBB
    OfgEZJSWIwqbtyBB
    MtDyDgjM5ObO6LDP

    • With the cover removed, simply remove and replace the gasket.

    • The straight side of the seal points upwards, the side with the lip points downwards.

    • Replace the seal cover by pressing it firmly until it clicks into place

Conclusion

Reinsert the water tank and enjoy a cup of coffee

Author

VauWeh

Member since: 19/10/15

234423 Reputation

2 comments

I was not able to remove the seal cover with a narrow plastic pry tool, the seal could not be pried out,

I did not want to use a lot of force in fear I might damage the two guide holes.

Any other suggestion will be greatly appreciated.

August Beza -

It was tough, but we were able to do remove it with a plastic tweezer alternating sides under the two posts. The plastic posts are tall. Keep at it.

Jeff Colorado -