Unbranded UB-15MS10 Motherboard Replacement

Written By: Matthew Sylvia
  • Comments: 2
Unbranded UB-15MS10 Motherboard Replacement

Difficulty

Easy

Steps

11

Time Required

1 hour

Introduction

  1. ZPAOIVViMBnsOewn
    ZPAOIVViMBnsOewn
    SUDnJqI5EDpkm1Kv
    eFdwAPseIqOlduXe

    • Use an opening tool to pry off the memory card door located on the back of the tablet.

  2. LRGWifjGtqjxirV6

    • Remove the two 1.2mm screws found under the memory card door.

  3. hEa2gHtOfkV2Y25e
    hEa2gHtOfkV2Y25e
    gGkQ5RwSxO4p4xsL
    c15YmPyJaMTfKICx

    • Pry around the outside carefully using the black spudger to get in.

    • Putting many opening tools around the edge helps keep it from sealing shut again.

  4. WTIgLZmdyJO3BGME
    WTIgLZmdyJO3BGME
    C2CIEdRAImZLoVtR

    • Remove the ribbon cable by using the black spudger to release the tab and carefully pull out the ribbon cable.

  5. gDKD3EdtCdIFv6mT
    gDKD3EdtCdIFv6mT
    QKtCXOT1n2EKkCxS
    fiTWF5cv1ViviXOM

    • Peel up the grey tape so that you can get to the board and untape the ribbon cable that was removed from the motherboard in the previous step.

  6. QftVuXbLYIPDUyYX
    QftVuXbLYIPDUyYX
    UKMHYbkaAwLSJbRJ

    • Remove the five 1.2mm screws from the board.

    Hi I have the same tab and I am looking for a bios chip and I cant find it , can you tell me how to find it

    John2en3 -

  7. hRnJUQk6HEhBjkur

    • Use an opening tool to remove the board from the case.

  8. 1Jc1NjE1nPQGuexS
    1Jc1NjE1nPQGuexS
    WPjKGIdyOMLaLPjj

    • Detach the three ribbon cables using a spudger

    • Desolder the black, white, and red wires.

  9. DPnmuqMENYRVe4oU

    • Unscrew the two 1.2mm screws from the speaker.

    • These screws are wired to the motherboard.

  10. SNjEUUaVeKflXSjY

    • Unscrew the two 1.2mm screws of the other speaker.

    • These screws are also wired to the motherboard.

  11. 6jwqswQL1A4tGaWC

    • Remove the old motherboard from the tablet.

    • Take the new motherboard and solder the black wire of the board to the black wire of the battery.

    • Do the same for the white and red wires.

Conclusion

To reassemble your device, follow steps 1-10 in reverse order.

Author

Matthew Sylvia

Member since: 08/03/17

280 Reputation

One comment

Please where can I get the motherboard or charging IC of UB15MS10

Ayo Olowo -