Toloco EM26 Small Washers Replacement

Written By: Zachary Olsen
  • Comments: 0
Toloco EM26 Small Washers Replacement

Difficulty

Moderate

Steps

6

Time Required

10 - 15 minutes

Introduction

Is your device making excessive noise? The following are the steps to take to replace the two small washers connected to the lever arm. Broken or malfunctioning washers can cause noises and a less smooth massage. Thus, if the massage gun makes noises it is not supposed to make, a replacement of said washers might be a solution.

  1. 5Gsa1pZYDqYpcHfY
    5Gsa1pZYDqYpcHfY
    rJhH6jwQmQkkBnP1

    • Remove rubber pieces at the bottom of the massage gun’s barrel with the spudger by inserting it between the rubber and the plastic and use the tip of the spudger to pry the rubber out.

  2. kiaClYt5WDy5AB2O

    • Remove the two 13.48 mm screws on the bottom of the massage gun with a Phillips #00 screwdriver.

  3. hLMijaMRXGXXpymI
    hLMijaMRXGXXpymI
    koMLf1wVUBQa5sJJ

    • Remove the 8.11 mm small black screw on the edge of circular plate with a Phillips #00 Screwdriver.

  4. QYUdDHVDgJliZJFp

    • Take off the cap of the massage gun by simply lifting it off the device.

    • Be careful to secure the cap as the back part of the gun may fall.

  5. wZJQiScjYDlU1Ewp
    wZJQiScjYDlU1Ewp
    nOWUeNZiw2OiBxFb

    • Remove the 19.9 mm silver screw with the hex bit attachment.

  6. CKCiucKNjteoisRK

    • Remove 1 thin silver metallic washer, and 1 thick black metallic washer.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Zachary Olsen

Member since: 08/09/23

536 Reputation

0 comments