Introduction

Is your touch screen is not working? This guide explains how to remove and replace the large motherboard located on the backside of the touch plate. For this repair you will need a black spudger and Phillips #00 screwdriver.

The motherboard is the brain of every electronic device. Its malfunction can cause a failure of the entire device or certain functions. Hence, if you experience malfunction issues it might be caused by a broken motherboard.

  1. KHJa4TOBjfrq6epC
    KHJa4TOBjfrq6epC
    6H1NsuJIAc312Q4h
    • Remove rubber pieces at the bottom of the massage gun’s barrel with the spudger by inserting it between the rubber and the plastic, and use the tip of the spudger to pry the rubber out.

  2. Y6kcBjGZJoc5BM62
    • Remove the two 13.48 mm screws on the bottom of the massage gun with a Phillips #00 screwdriver.

  3. 2fg3faFlNDDhjjTF
    2fg3faFlNDDhjjTF
    64Kp2qKVScVhMv4e
    • Remove the 8.11 mm small black screw on the edge of circular plate with a Phillips #00 Screwdriver.

  4. qIp2SlBoSQIvTKvw
    • Take off the cap of the massage gun by simply lifting it off the device.

    • Be careful to secure the cap as the back part of the gun may fall.

  5. IgO2UvZbQFoUeRgL
    • Pull out back touch plate to access the large motherboard.

  6. gLOKkEI3HRDK4mtM
    gLOKkEI3HRDK4mtM
    Z54eDsyJuQlKDto3
    • Unplug the three cables on large motherboard.

    • The largest cable has a tiny lever which has to be pressed down first to remove.

  7. 3VbM43QlNIISwWMt
    • Remove the three 7.66 mm silver screws on the large motherboard with the Phillips #00 screwdriver.

  8. wWSVF6v2PYHSWTUl
    • Remove large motherboard for replacement.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Zachary Olsen

Member since: 08/09/23

536 Reputation

One comment

Greetings!

Any idea where to get replacement parts for the Toloco EM26 massage gun?

Thanks,

Kev

Kevixfix -