Introduction

This guides will show you how to replace the battery in your Sony Xperia Z5.

  1. WiWxfoKEVkLx2wQt
    WiWxfoKEVkLx2wQt
    BqB4B4MkWFqcNgrX
    • Remove SIM card tray.

  2. ussACdQWFBShhFIF
    ussACdQWFBShhFIF
    kHBJZfeo2HQDKRZ5
    • Heat the back cover to soften the adhesive.

    • Place the suction cup and insert metal opening tool to open a gap from top side.

    Any recommendation on how hot and how long to heat it up?

    Benedikt M. -

  3. VlALyqFVLjXIF4pK
    VlALyqFVLjXIF4pK
    dVNXMomlJmGAPsNW
    QsL31Pnyg5RsW4nc
    • Insert the guitar picks and slide it to cut the adhesive underneath.

    • Remove back cover.

    Does the adhesive in this step need to be replaced? Don't really want to lose the water proofing…

    Harald McArthur -

    Usually the adhesive is slightly damaged during the opening procedure which might void the water resistance of the phone. So to re-seal the back cover it’s best to use fresh adhesive. If you don’t find a pre-cut adhesive tailored to the Z5 you can go with double-sided adhesive tape or an adhesive glue. If you find the remaining adhesive in good condition and trust it to do its job, the re-use it by heating it up a little bit and applying pressure to the re-attached back cover for a few hours.

    Tobias Isakeit -

  4. ECkFXYg1tnDu5LZn
    ECkFXYg1tnDu5LZn
    kGkHfHnIjjXaUCap
    L6dI4grHjyNRXvMG
    • Release battery connector and pull off the adhesive tape underneath.

    • Pry up battery.

    Can you tell me the wire connection colour code of battery? because i brought the ones but its not working.

    denkim2701 -

Lenka

Member since: 06/11/15

2408 Reputation

7 comments

I missed the part about the adhesive for the battery and broke the tabs off. Made it slightly harder but I got it. Thanks for the instructions. Now I can get all my things off of it

Braydon -

can you put a link to where i could buy the battery from? it would be helpful, thank you

ido r -

worked a treat - simple straightforward - thanks!!

John Turnbull -

umm how do you put the cover back on?

Dulantha Fernando -

Just push and then consolidate with heat, I used hair dryer.

Jorge García Laosa -

can reuse the same cover, or need a new unit ?

Chu Tat Liang -

Will this work for z5 premium ???

Q8Lucifer -