Sony Ericsson W810I Charger Adapter Replacement

Written By: Ben Micucci
  • Comments: 0
Sony Ericsson W810I Charger Adapter Replacement

Difficulty

Moderate

Steps

7

Time Required

10 - 30 minutes

Introduction

This guide will show the user how to replace the charger adapter for the W810i

  1. bJBrJlpTFR13Tkia

    • Power the phone off.

    • Press down firmly against the icon on the lower rear panel with your thumb.

    • Slide the panel down to remove it.

  2. POgnfQ1aYNTiyNCR
    POgnfQ1aYNTiyNCR
    UMoFfWDKEgtnoV2t

    • Lift the battery and pull it out.

    • Remove the SIM card too if you have one.

  3. XknKmbAbNRPFVj1G
    XknKmbAbNRPFVj1G
    I1E2TtFKRioYEJQP

    • Remove the following screws:

    • Two T7 Torx screws

    • Two Phillips #00 screws

  4. 22pBANRSnrhx1KJI
    22pBANRSnrhx1KJI
    ZJTeLLbZQAopH41q

    • Use an opening tool to remove the camera faceplate.

    • Be careful to not bend the camera faceplate when removing it.

  5. 6DrWCohOuLLwtLtP
    6DrWCohOuLLwtLtP
    4YFnDE1tWpqLbKnx
    ZQtJeHfcGHeDTThk

    • Flip the phone over and use an opening tool to pry off the number pad.

    • Separate the keypad from the motherboard.

  6. ssPl3aLNh5LGgST3

    • Remove two T6 Torx screws that secure the motherboard.

    • Use an opening tool to remove the motherboard. Pay attention to cables on the motherboard.

    • Do not pry too hard on the motherboard, as it can break under too much force.

  7. VgxihtdRD1bjHJIc

    • Pull off charger adapter and remove it.

    • Pull evenly on the full width of the cable so that no individual wires are overly strained.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ben Micucci

Member since: 14/10/11

186 Reputation

0 comments