Solio Rocsta Internal Components Replacement

Written By: Aimee Whiteside
  • Comments: 0
Solio Rocsta Internal Components Replacement

Difficulty

Moderate

Steps

7

Time Required

No estimate

Introduction

This guide shows you how to remove the battery and motherboard from the body of the Solio Rocsta.

  1. euFKgTBNvb2BjhQc

    • Remove the three 7mm Torx T7 screws.

  2. 1v6oJyEhDcM6RxEE
    1v6oJyEhDcM6RxEE
    RZULLpLjIC6J6PUZ
    jEySAWRvuGpTVEiF

    • Insert the flat end of the spudger between the top panel and the body.

    • Use the spudger as a lever to carefully pry apart the two panels.

    • As you pry, take care not to break the small orange clip holding the top to the body.

    • Lift the panel above and away to disconnect the panel from the body.

    • Be careful when lifting because you could break the wiring connecting the motherboard to the panel.

  3. n1mgpMURkMNQApLD
    n1mgpMURkMNQApLD
    M5AW5nAcTAkhZhZW

    • Lift the panel off the body and set it next to the device.

    • Remember to use caution when lifting because you could break the wiring connecting the motherboard to the panel.

  4. BBCW5RaHKDaoUu2U

    • Remove the two 6mm Torx T6 screws from the motherboard.

  5. YDU1JNbsaUVSgsbJ
    YDU1JNbsaUVSgsbJ
    EgAv4LZ5smC2afiW

    • Lift the end of the USB cord out of the body.

    • The cord fits over an orange peg.

  6. ZQq1NnIA3VsuJMUr
    ZQq1NnIA3VsuJMUr
    AUkWnTcxWKvcIOAP
    PqJXHNec1OZHiYo2

    • Lift up the battery with your fingers or with the flat end of the spudger.

    • Be prepared to use force because the battery is adhered to the body.

    • Do not try to remove the battery completely because the wiring connects to the motherboard.

  7. 6lZux3hbx5dIX3LO
    6lZux3hbx5dIX3LO
    nP6bWGwUFTBCVZqX

    • Remove the battery and the motherboard from the body.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Aimee Whiteside

Member since: 21/05/15

1 Reputation

0 comments