Siemens Surpresso - Open Bosch Benvenuto

Written By: VauWeh
  • Comments: 0
Siemens Surpresso - Open Bosch Benvenuto

Difficulty

Moderate

Steps

6

Time Required

No estimate

Introduction

For many repairs, the device must be opened. This is described here.

These instructions may also help with other Siemens/Bosch models and with coffee makers from Nivona, Melitta, and Miele—they have a very similar design.

  1. shtZT3V3uVjFWGD3
    shtZT3V3uVjFWGD3
    JgLdVOn63gDfwXOv
    BQSTyjZBOvDhUauV

    • Never forget: Pull the power plug!

    • Remove all attachments such as water reservoir, coffee compartment lid, trester drawer.

    • Remove all coffee beans from the bean hopper.

    • Open the side flap.

  2. BBZCGHlQPZ6KcXPe
    BBZCGHlQPZ6KcXPe
    xf2xARrNTmTHS1kO
    mXtw3GRXIiMaG1dg

    • Loosen the three rubber caps on the brew group.

    • Using a strong flat-blade screwdriver, adjust the three plastic slots underneath so that the "unlocked" position is indicated.

    • Note: with the newer version of the brew group, only one lever needs to be flipped.

    • Pull out the brew group. If it is stuck, pull firmly and evenly, but with feeling, preferably at the bottom right.

  3. cOUklpFp6AmA11p3
    cOUklpFp6AmA11p3
    XuCAWGZ2tDPAIqJd

    • Remove the seven Torx T10 screws on the rear panel.

    • Do not remove the back panel completely yet, the power switch is still connected.

    • Lift the back panel away.

    • Remove the two flat plugs from the inside of the power switch.

  4. rxLKLIpSnwtpLBNX
    rxLKLIpSnwtpLBNX
    PaomBApodaRoNR1D
    Z2OqwvxXeXENDNTF

    • The top cover is engaged with bayonets in several places. It must first be pushed back about 1 cm and then lifted away upwards.

    • Grasp the powder compartment cover firmly and pull it upwards out of its hinges. Otherwise it will be in the way of the top cover.

    • Pull the top cover back about 1 cm. If it sticks in front, you can help a little with plastic levers.

    • Lift the top cover away from the top.

  5. kboIKYxdomU25eBb
    kboIKYxdomU25eBb
    TJyYQrVwrVZ3OYmF

    • The side panel is attached to the front edge with three bayonets. It must therefore be lifted out upward.

    • Grasp the side panel firmly at the rear edge and pull it backward and upward at the same time. It should come off quite easily.

    • When reassembling, make sure that the bayonets on the front edge engage properly.

  6. 5MeWpgXB1VHFRrZj

    • The side panel is attached to the front edge with three bayonets. It must therefore be lifted out upward.

    • Grasp the side panel firmly at the rear edge and pull it backward and upward at the same time. It should come off quite easily.

    • When reassembling, make sure that the bayonets on the front edge engage properly.

Conclusion

Follow the steps in reverse order to reassemble your device

Author

VauWeh

Member since: 19/10/15

234462 Reputation

0 comments