Samsung Galaxy J7 Midframe Replacement

Written By: Timothy Grubb
  • Comments: 0
Samsung Galaxy J7 Midframe Replacement

Difficulty

Moderate

Steps

4

Time Required

10 minutes

Introduction

  1. Kbe6xYKIosxh4KEY
    Kbe6xYKIosxh4KEY
    G3UyHOgnKTldDysd

    • Locate the Tab: Find the tab at the top left corner of the back cover. (highlighted by red square)

    • Insert the tool: Use a fingernail or a plastic opening tool to lift the tab gently

    • Pry open the cover: Carefully work around the edges to remove the back cover completely

    • Tip: If cover is stuck do not force it open use a plastic opening tool to avoid scratching

  2. AVw5XROgUkVB5FmI
    AVw5XROgUkVB5FmI
    XVMjCQHxhrut2jYw

    • Locate the Battery slot: Find the small slit at the bottom right corner of the battery (highlighted by red square)

    • Remove Battery: Gently pop out the edge and carefully pull out the battery.

    • Tip: Ensure the battery is disconnected from the motherboard before removing it.

  3. VI2TQsh5aUxKBajV

    • Using the Phillips #000 screwdriver, remove the ten 4.2 mm screws around the edge of the midframe.

  4. PMd14C2nc5QsRmij
    PMd14C2nc5QsRmij
    m233EknFPpKanVHU
    ZlkVNHvWC1MGdDeK

    • Lift up the back of the device with the iFixit opening tool and disconnect it from the front.

    • If the back panel is difficult to remove, gently heat the edges using a hair dryer or heat gun to soften the adhesive.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Timothy Grubb

Member since: 05/02/19

680 Reputation

0 comments