Rosewill NEON M62 Cable Replacement

Written By: Julian Abraham
  • Comments: 0
Rosewill NEON M62 Cable Replacement

Difficulty

Moderate

Steps

5

Time Required

3 - 5 minutes

Introduction

This guide explains how to replace the USB cable on the Rosewill NEON M62 mouse. This repair should be done if the cable is visually broken or your computer does not recognize the mouse when plugged into it.

  1. sCWWMNXZ1ISW2Eb3

    • Place the mouse so the bottom is facing upwards.

    • Remove the plastic skates.

    • These are not shown in the picture since they were missing from the device.

    • Remove the two 5 mm screws with a Phillips #00 screwdriver.

  2. DqR5tgX1LeEHdFpg

    • Use the opening tool along the side of the mouse to open up it.

    • This may take multiple attempts to do so; be patient and careful not to break the mouse.

  3. kPcPjqwM5LFOUNB4
    kPcPjqwM5LFOUNB4
    Hrg3CnCQKRmDnUUb

    • Loosen the top and bottom half of the mouse with the opening tool, and slowly pull up the bottom half of the mouse.

  4. pW1KgIXitf2xDjMM
    pW1KgIXitf2xDjMM
    K6DCBnUppLZdqtTB

    • Gently pull the cable toward yourself and around the right side, being careful not to damage the wires.

  5. PGRLI62Pro2JwtrP

    • Carefully, using your fingers or tweezers, pull the white connecter up.

    • Do not pull by the wires.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Julian Abraham

Member since: 21/03/23

414 Reputation

0 comments