Roconia Q6 Top Cover Replacement

Written By: Elizabeth
  • Comments: 0
Roconia Q6 Top Cover Replacement

Difficulty

Easy

Steps

4

Time Required

8 minutes

Introduction

This guide will show you how to open your Roconia device to access its internal components.

  1. 3XlJtx1gXGGNa2jy
    3XlJtx1gXGGNa2jy
    4KkxCAIpSgsAb2Lb

    • Flip your device upside down so that the interface is facing downwards.

  2. EVvnGY1DBQGP5ZkC
    EVvnGY1DBQGP5ZkC
    FRZpEKYUKBXMgGJD
    vkRDRip4kpZWJxNO

    • The device is supported by rubber pieces located at the bottom extremities.

    • There are screws beneath the rubber pieces that can be removed. Remove all four 1.1 mm Phillips #1 screws by using the Phillips #0 screwdriver.

  3. FFjm2Iq2ppjUPZAL
    FFjm2Iq2ppjUPZAL
    dlWgw2Hu2IdBxBCO
    J2jGaUxbnnsDLykr

    • Turn device over again and pry open the device to remove the cover.

  4. cNbsiWBnWcRJPrAM
    cNbsiWBnWcRJPrAM
    NtyPvB52uN2ZixKv
    iA4llaOaKLfPiEIF

    • Pull out the cable that is connected to the top cover to fully separate.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Elizabeth

Member since: 08/02/24

244 Reputation

0 comments