Roconia Q6 OK Button Replacement

Written By: Janki T
  • Comments: 0
Roconia Q6 OK Button Replacement

Difficulty

Easy

Steps

6

Time Required

10 minutes

Introduction

This manual provides instructions for changing the Ronconia Q6 projector's OK button. The OK button is crucial for menu navigation and selection confirmation. Whether you're a novice or experienced, this guide offers straightforward, easy-to-follow steps to simplify the replacement process.

  1. 3XlJtx1gXGGNa2jy
    3XlJtx1gXGGNa2jy
    4KkxCAIpSgsAb2Lb

    • Flip your device upside down so that the interface is facing downwards.

  2. EVvnGY1DBQGP5ZkC
    EVvnGY1DBQGP5ZkC
    FRZpEKYUKBXMgGJD
    vkRDRip4kpZWJxNO

    • The device is supported by rubber pieces located at the bottom extremities.

    • There are screws beneath the rubber pieces that can be removed. Remove all four 1.1 mm Phillips #1 screws by using the Phillips #0 screwdriver.

  3. FFjm2Iq2ppjUPZAL
    FFjm2Iq2ppjUPZAL
    dlWgw2Hu2IdBxBCO
    J2jGaUxbnnsDLykr

    • Turn device over again and pry open the device to remove the cover.

  4. cNbsiWBnWcRJPrAM
    cNbsiWBnWcRJPrAM
    NtyPvB52uN2ZixKv
    iA4llaOaKLfPiEIF

    • Pull out the cable that is connected to the top cover to fully separate.

  5. GqHFyUicxIOAy5nd
    GqHFyUicxIOAy5nd
    tFSWEQIFDuBQekqx

    • Use a Phillips #0 screwdriver to remove each of the 5.2 mm screws from the sensor board inside the cover.

  6. IeGUYaWHKbZl3qB4
    IeGUYaWHKbZl3qB4
    JZAmrtWNRK2BQnCc
    1gWWTLQ6132rINtv

    • Remove the motherboard and you will see the the pieces that help control the buttons.

    • Locate where the OK button is placed.

    • Remove the part that helps control the OK button by pulling it out

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Janki T

Member since: 13/02/24

273 Reputation

0 comments