Introduction
-
-
Press the USB-C port board flat to the frame to re-engage the metal springs, making sure the alignment pegs fit into their holes in the board.
-
-
-
While holding the board in place, use a Torx Plus 3IP driver to install the three 2.6 mm‑long screws securing the USB-C port board.
-
-
-
Use tweezers, or your fingers, to remove the old adhesive under the USB-C port cable.
-
Peel the new USB-C port cable adhesive strip from its clear liner.
-
Align the adhesive strip over its spot in the frame and lay it down with the colored pull tab facing the right edge of the phone.
-
-
-
Use the flat end of a spudger, or your fingers, to press down the adhesive and adhere it to the frame.
-
Peel off the colored liner to expose the adhesive.
-
To reassemble your device, follow these instructions in reverse order.
