Reassembly: Loudspeaker

Use tweezers, or your fingers, to remove the bottom and top conductive fabrics or the loudspeaker cable adhesive if they're not intact.

Align the bottom loudspeaker conductive fabric on the underside of the loudspeaker.

Remove the conductive fabric from its clear and colored liners and lay it over its spot on the loudspeaker.

Use the flat end of a spudger, or your fingers, to press down the conductive fabric and adhere it to the loudspeaker.

Peel the clear liner off the loudspeaker cable adhesive.

Align the adhesive over the loudspeaker cable and lay it down, making sure not to cover the hole in the cable.

Use your fingers to lightly pinch the cable and adhere the adhesive strip.

Remove the blue liner from the adhesive strip.

Align the hole in the loudspeaker cable over its peg on the frame.

Press down the cable with the tip of a spudger, or your finger, to adhere it to the frame.

While pressing the cable down, reinsert the loudspeaker at an angle into its recess and press it flat to the frame.

While holding the loudspeaker in place, use a Torx Plus 3IP driver to install the 2.6 mm‑long screw securing the loudspeaker.

Peel off the clear liner on the top loudspeaker conductive fabric.

Peel off the small colored liner covering the rounded corner of the fabric.

Align the rounded corner of the conductive fabric with the same‑shaped marking on the frame.

Lay the fabric down onto the frame and the loudspeaker.

Use the flat end of a spudger, or your fingers, to press down the conductive fabric and adhere it to the frame and loudspeaker.

Peel off the large colored liner from the conductive fabric.