Reassembly: Inner Front Camera

Use tweezers, or your fingers, to remove the old adhesive foam from the inner front camera cutout.

Use isopropyl alcohol (>90% or greater) and a coffee filter or lint‑free cloth to remove any adhesive residue.

Peel the replacement adhesive foam off its clear liner to expose the adhesive underneath.

Align the adhesive foam over the cutout in the frame so that the pull tab is facing the bottom of the phone.

Place the adhesive in the cutout.

Use the tip of a spudger to press along the edges of the adhesive foam to secure it to the frame.

Use tweezers, or your fingers, to peel off the colored liner and expose the adhesive underneath.

While holding the inner front camera above its cutout, reconnect its press connector.

Lay the inner front camera in its cutout and press down to secure it to the adhesive.

Reinsert the inner front camera bracket clip under its slot in the logic board and align the screw holes.

Use a Torx Plus 3IP driver to install the two 2.6 mm‑long screws securing the inner front camera bracket.