Palm Pre Speaker Replacement

Written By: iDeleted
  • Comments: 0
Palm Pre Speaker Replacement

Difficulty

Very easy

Steps

4

Time Required

No estimate

Introduction

This guide will show you how to readjust or replace the speaker if it is performing poorly.

  1. dRQv46IeI3fjA6nZ
    dRQv46IeI3fjA6nZ
    oSVxTNPAaXOO2gDR

    • First the back panel must be removed to reveal the battery.

    • Remove the battery pack.

  2. nL5Gh53GsktID22C
    nL5Gh53GsktID22C
    N2nKrCFApQGvohKL

    • Remove the six T5 screws necessary to separate the backplate from the phone.

    • There is one screw in the upper right that is concealed by a small sticker labeled "Palm."

    • Additionally, there are interlocking tabs securing the back plate around the edges.

    • Use the opening tool to carefully go around the phone releasing these tabs.

  3. 3AdMHByyfdFrAwWm
    3AdMHByyfdFrAwWm
    LZD2iRtSyp4nHUmD

    • Lift the metal flap marked in red to reveal the antenna connectors.

    • Carefully pry these the antennas from their connections, this can be done quite easily.

    • Take note of which colored wire is attached to each connection. The white wire corresponds to GPS, while the black wire corresponds to DIV, or diversity antenna.

  4. 6JvKONjVmEDAgQCr
    6JvKONjVmEDAgQCr
    HRhJeBMX3bNybORL
    lXXABUHPSHpI1PDw

    • With the backplate removed, the speaker is visible.

    • Pry out speaker with spudger.

    • It is magnetically attached so there should be a little bit of resistance; however, there are no wires to disconnect.

    • Take note of the orientation of the speaker for re-installation.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

iDeleted

Member since: 07/07/10

2101 Reputation

0 comments