PDP Victrix Pro BFG Joysticks Replacement

Written By: Jacob Gorman
  • Comments: 0
PDP Victrix Pro BFG Joysticks Replacement

Difficulty

Moderate

Steps

3

Time Required

5 - 10 minutes

Introduction

This is the guide for replacing the joysticks on your gaming controller, the PDP Victrix Pro BFG. Whether you're customizing your controller or fixing unresponsive buttons, this guide will walk you through the process. You can use this guide to replace the buttons aswell. Be sure to check the troubleshooting section for any related issues and handle parts with care to avoid damage or injury. Let's get started!

  1. dmGApYo4x2OtX5Eh

    • Use the purple Module Swap Tool that comes with the device to remove the 4 hex screws.

    • Remove the joystick/button modules from the controller.

  2. wNkaK4NZw2QcJnib
    wNkaK4NZw2QcJnib
    VqZyHRJpsVlmTTFa

    • Turn over the joystick/button module

    • Remove four 1 mm screws using a Phillips #0 screwdriver.

    • Take the plate off with the buttons and set aside.

    • You can use this step to replace the buttons if one is damaged or if you would like to customize them.

  3. YeroFt1uWEL4jRfx

    • Using a soldering iron, desolder the the bottom part of the joystick.

    • The soldering iron is very hot; be careful to not make contact with skin.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jacob Gorman

Member since: 20/03/24

197 Reputation

0 comments