Nokia Lumia 925 Battery Replacement

Written By: Guillermo Lara

Comments: 2

Difficulty

Difficult

Steps

Time Required

40 minutes

Introduction

Tools

Parts

Nokia Lumia 925 Battery

Step 1

Remove the sim card holder by inserting tweezers into the hole. Push down and the holder will spring back up.
Pull out the holder until it is completely separate.
Something like a paperclip will work if there are no tweezers available.

Step 2

Slide a plastic opening tool under the back cover.
Slide the tool around the outsides of the cover to fully dislodge the pins holding the cover to the phone.
Some pins are facing the opposite way from the others.

Step 3

Remove the 3 screws using the T7 Torx screwdriver.
Unclip the black tab connector.

Step 4

Remove the silver metal cover.
Be careful of the tape under the right square side of the panel. Using a spudger helps.

Step 5

Unclip the two orange tabs.
Remove the four silver screws using the T5 Torx screwdriver.

Step 6

Remove the motherboard by sliding tweezers between it and the back of the screen. Lift up.

Step 7

Push the screen from the inside of the phone.
Pull the screen off.
Slide the electronic strip through the small opening.

Step 8

Locate the grey speaker/camera cover.
Carefully remove the cover with either a pair of tweezers or your fingers.

Step 9

With a pair of tweezers, gently remove the orange colored tab closest to the speaker.

Step 10

Pull at the orange section until it becomes loose.
It is located in the upper leftmost section of the phone behind the front camera.

Step 11

Pull vertically on the same orange section until the front camera comes out.
The front camera as well as the speaker may come out after the last step so be careful.

Step 12

Remove the two black screws by using the T5 Torx screwdriver.

Step 13

Carefully pull the metal rod out.

Step 14

Pry off the speaker.
Apply heavy pressure, and pull towards the battery.

Step 15

Unclip the black wire.

Step 16

Peel off the electronic strip.
Be careful not to tear.

Step 17

Pry off the metal vibrating unit using tweezers.
This requires a lot of force.

Step 18

Insert the tweezers under the corner of the battery, and lift out.
You have successfully removed the battery.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Guillermo Lara

Member since: 18/09/18

409 Reputation

2 comments

Add markers to steps 10 and 11 for clarity. Add the battery to the “parts” section. For step 5 make sure the bullet color matches the marking color. Remember to add an introduction.

Jackson Reynolds - 27/11/18

\Some steps unnecessary e.g. remving the screen.

Also some other parts.

Use your brain.

malcolm redwood -