Introduction

If your device won't read SD cards you may need to replace the SD card reader. Be careful of the three tri-wing screws on the SD card reader, as these are soft and strip easily. Go slow and press down firmly on the screw.

  1. RHSiD64Y5wNXRkGt
    • Unscrew the two 3mm Phillips #1 head screws along the top edge of the device.

    • The screws on the back panel strip easily. Go slowly and press down firmly.

    • The screws on the back panel are held in by locking washers, so they won't come out of the back panel.

  2. pyUg6nSkGDKVCP3O
    pyUg6nSkGDKVCP3O
    kOxjUY5qGoETmTkf
    • Pull the top corner tabs of the front face plate outward and towards you.

    • Pull the faceplate up and out of the slots at the bottom of the device.

    • Set aside the back faceplate.

  3. IIi1SwaGDQqyIPpg
    IIi1SwaGDQqyIPpg
    PARFKZinVRBM4rsM
    YNIIJ4jiaWmyWtlG
    • Insert a plastic opening tool into the notch at the top of the battery.

    • Pry the battery up with the plastic opening tool.

  4. hcFYj1TArfneoJqY
    • Unscrew the three 3mm Y0 screws along the right and bottom of the SD card reader.

    • The bottom of the SD card reader should slightly pop out after removing the screws.

  5. WcQtiVnntpunAVvu
    • Pull the SD card reader from the edge with two holes gently to free the tab at the top of the SD card reader.

    • Don't completely pull the SD card out of the device yet. There is a ribbon cable connected under the SD card reader.

    • Reorient the device so that the power jack faces you.

  6. WRckhfKBMm2mkIsJ
    WRckhfKBMm2mkIsJ
    cGAFg3mXyeQf3Xno
    • Lift the SD card reader gently.

    • Use a plastic opening tool to pry the SD card ribbon cable off the socket on the motherboard.

    • Lift the SD card reader out off of the lower casing.

    Where can I buy a new SD card reader? Cant seem to find any.

    Aldair -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tyler Starr

Member since: 06/10/16

1621 Reputation

0 comments