NABI XD Charging port Replacement

Written By: Marissa Schiereck
  • Comments: 0
NABI XD Charging port Replacement

Difficulty

Moderate

Steps

6

Time Required

1 minute

Introduction

Is your charging port damaged, can't charge your device no matter what you have tried. Replacing the charging port may fix those problems.

  1. YdCpZJcuykPtmdKf
    YdCpZJcuykPtmdKf
    eknSnaqnGvJSQuXU

    • Use the plastic opening tool at the top left corner seam, then pry the corner apart.

  2. EGPZLMveVZPl6BW6

    • Next slide the plastic opening tool across the sides of the Nabi. It will slowly open.

    • There are small plastic clips that need to be release. Gently apply outwards pressure until the clips give.

    • Go around the NABI XD and separate the rear panel from the device.

  3. FmZSHCRZpSHxwp4s
    FmZSHCRZpSHxwp4s
    vWxcuBM6cRBYaiqW

    • Place your fingernails on both sides of the connector and pull it straight back away from the holder.

  4. PX66NaiHLXQcT2VP

    • Battery is glued to the base, lift carefully.

    • To remove battery, lift the battery up from the motherboard.

  5. WduoI52OV1uJW2IF
    WduoI52OV1uJW2IF
    pGJpaqGXgqmLjJ1s

    • Remove the two 4mm Phillips screws with the PH#0 screwdriver.

    • Disconnect the left (L) speaker wire from the charging port by grabbing it on both sides with the tweezers and pulling straight back.

  6. WDbBVTAdtKP2hiSn

    • Use your fingernails or a spudger to flip up the small retaining flap, then pull the ribbon straight back to remove

    • Lift the charging port from the NABI XD.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Marissa Schiereck

Member since: 15/09/16

638 Reputation

0 comments