Tools
-
-
The backside is fixed with seven Torx T10 screws. Unscrew them
-
Get the Backside of. It should be a bit stuck.
-
-
-
Pull the powder compartment up.
-
Pull one of the sides of the Powder compartment out of the hinge and loosen the lid.
-
Remove the powder compartment
-
-
-
In the powder compartment, you should see a rubber cover. Loosen the rubber cover with the appropriate tools.
-
There should also be a Torx T10 screw. Unscrew it
-
-
-
The upper cover with the brewing unit is held up from three clamps. These can be reached through a slit.
-
Press these clams with a flat scredriver in and pull the upper cover up, until the clamps loosen.
-
-
-
On the side that has a a watertank you can find 2 other clamps
-
Press these clamps with a flat scredriver in and pull the cover up until they loosen
-
Lift the upper cover and the backside up, hook it on the front edge and remove them
-
-
-
Push the right and the left side panel back, then pull the lower edge out and pull the side panel out.
-
On the side panel with the watertank, there should be a supply hose attached to a cable that connects the water-level sensore. loosen them
-
Hint: the side panel doesn't have to be removed completely for each repair.
-
Work through the steps in reverse order, to rebuild your machine.
