Maze Speed SSB-508 Speaker and Microphone Replacement

Written By: Bryce Stewart

Comments: 2

Maze Speed SSB-508 Speaker and Microphone Replacement

Difficulty

Moderate

Steps

Time Required

10 minutes

Introduction

This guide will provide instructions for removing the speaker and mic in a Maze Speed phone. You will need a plastic opening tool, screwdriver, tweezers and soldering equipment. You should know how to solder to avoid damaging other components in the phone.

Tools

Step 1

With the phone face down, remove the back cover with the plastic opening tool. For easiest access, insert the plastic opening tool in the bottom left corner.

Step 2

After the back cover is removed, remove the battery, sim cards, and micro SD card. These components are highlighted in red.

Step 3

Using the screwdriver, remove fourteen 2mm screws to access the internal casing of the phone.
After the screws are removed, use the plastic opening tool to remove the internal casing cover.

Make sure to add the markup shot, as requested in iFixit’s feedback. You can just add new markup to the old whole phone shot.

Alex Watkins - 31/07/19

Step 4

Locate the wire that attaches the motherboard to the daughter-board of the speaker and mic. Using tweezers, disconnect the wire from the motherboard.

Check subject-verb agreement here.

Alex Watkins - 31/07/19

Step 5

Using your soldering tools, un-solder both set of wires that are connected to the daughter-board.
You may now replace the old speaker and mic with new accessories.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Bryce Stewart

Member since: 09/07/19

139 Reputation