MNT Pocket Reform Bottom Cover Replacement

Written By: Spencer Pennington
  • Comments: 0
MNT Pocket Reform Bottom Cover Replacement

Difficulty

Easy

Steps

4

Time Required

2 - 5 minutes

Introduction

Follow this guide to replace the bottom cover on your MNT Pocket Reform laptop.

If the bottom cover of your Pocket Reform is scratched or damaged, you may want to replace it. You can find specs to make your own bottom cover on MNT's documentation page.

  1. lAkyyLZ2FhXZDSCq
    lAkyyLZ2FhXZDSCq
    vGnreJUBFBdMSfvJ
    tRYxAAsVn3KgmiyB

    • If you've installed an operating system, follow the appropriate steps to safely shut down the laptop.

    • If you've not yet installed an operating system, or the laptop is not responsive, you can shut it down with these steps:

    • Turn on the OLED screen by pressing the Hyper key (diagonal arrow) and Enter at the same time.

    • Use the arrow keys to select Power Off on the OLED screen.

    • Press Enter to shut down the laptop.

    • Disconnect all cables from the laptop.

  2. TgtCHpwWDSAgTP6f
    TgtCHpwWDSAgTP6f
    rhnyB1WrNdIxACfb

    • Use a small tool, like a SIM eject tool or a bent paperclip, to turn off the standby power switch by sliding the switch away from the headset jack.

    • The standby power switch is located in a small recess on the same side as the headset jack.

  3. HNchsvh3N1phHnqT
    HNchsvh3N1phHnqT
    fHCtJUcfrjoAMwqZ

    • Place the laptop on your work surface so the bottom cover, with the regulatory info box, is facing up.

    • Use a Phillips screwdriver to remove the six 4.8 mm‑long screws securing the bottom cover.

  4. Q4pmGoVXtLLOvg1y
    Q4pmGoVXtLLOvg1y
    bLaJdFXkPXCRKhSk
    kAEQNKVMQuETfiEM

    • The bottom cover is made of printed circuit board (PCB) material. Press gently but firmly near an edge when applying the suction handle to avoid breaking the cover.

    • Apply a suction handle to the bottom cover.

    • Use the suction handle to lift the bottom cover off of the laptop.

    • Alternatively, you can use a thin prying tool to lift the cover, or tilt the laptop until the cover falls out.

    • During reassembly, place the bottom cover on the laptop so the info box is opposite the hinges.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Author

Spencer Pennington

Member since: 09/09/23

13296 Reputation

0 comments