Logitech Gamepad F310 Trigger Spring Replacement

Written By: Alan Mendoza DracoKing
  • Comments: 0
Logitech Gamepad F310 Trigger Spring Replacement

Difficulty

Moderate

Steps

6

Time Required

10 minutes

Introduction

If your triggers on your Logitech Gamepad F310 seem to be loose or broken, you might need to replace the springs inside them. Luckily this is a fairly easy process. Follow this guide to replace the springs on the triggers for your Gamepad controller.

The trigger spring is to help make trigger return back original position. The trigger is special function for gaming purpose like aiming, zooming and etc. So those are reason to replace trigger spring.

No special tools or skills are required.

  1. 5X4mDBDlm4aCpX1U
    5X4mDBDlm4aCpX1U
    ykdOIWy5uogN3YJL

    • Use a Phillips #1 screwdriver to remove all seven 3 mm screws that secure the rear case.

  2. ENHWNNOBAUMSMUUG
    ENHWNNOBAUMSMUUG
    VZVjqsEXtmDEFLfE

    • Press along the seams of the controller and gently pull the front and rear case apart.

    • If necessary, use an opening tool to help pry the front and rear case apart.

    • Make sure to open the controller with the front facing down so that the buttons do not fall out.

  3. pPS1JtQ3XEj1P4sw

    • Separate the front and rear case.

    • There are two side panels on the controller that come apart as well. When putting them back together, they slot into place on the sides of the controller.

  4. SuHUvlSVCMxqlX2k
    SuHUvlSVCMxqlX2k
    bNEdHVctRafoQySd

    • Use a Phillips #1 screwdriver to remove:

    • Four 3 mm screws

    • One 5 mm screw

    • Remove the central silver screw last.

    • Gently lift the motherboard off of the back case and slide the cord out of the top slot.

  5. BPd42RqGnZwVhyUU

    • Make note of the slot on the controller and the slot on the trigger that the spring is connected to.

    • Press the trigger down until the spring pops loose.

    • You may need to fish the spring out of the pocket it is in. The spring will be accompanied by a small black piece that fits inside the spring.

  6. MGDcRFrlbpY6Xcky

    • In order to properly place the spring into the controller, make sure that the black piece is inside, and make sure each end of the spring goes into the correct slots.

Conclusion

You're all finished! To reassemble your device, follow these instructions carefully in reverse order.

Author

Alan Mendoza DracoKing

Member since: 05/02/24

169 Reputation

0 comments