Logitech Gamepad F310 Disassembly

Written By: Lucas Stovall
  • Comments: 0
Logitech Gamepad F310 Disassembly

Difficulty

Easy

Steps

3

Time Required

5 minutes

Introduction

This is a prerequisite guide for the disassembly of the case of the Logitech Gamepad F310. Disassembly of the case is an important part for making any replacement to the Gamepad.

  1. 5X4mDBDlm4aCpX1U
    5X4mDBDlm4aCpX1U
    ykdOIWy5uogN3YJL

    • Use a Phillips #1 screwdriver to remove all seven 3 mm screws that secure the rear case.

  2. ENHWNNOBAUMSMUUG
    ENHWNNOBAUMSMUUG
    VZVjqsEXtmDEFLfE

    • Press along the seams of the controller and gently pull the front and rear case apart.

    • If necessary, use an opening tool to help pry the front and rear case apart.

    • Make sure to open the controller with the front facing down so that the buttons do not fall out.

  3. pPS1JtQ3XEj1P4sw

    • Separate the front and rear case.

    • There are two side panels on the controller that come apart as well. When putting them back together, they slot into place on the sides of the controller.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Lucas Stovall

Member since: 07/02/24

319 Reputation

0 comments