Logitech Gamepad F310 Case Replacement

Written By: Alan Mendoza DracoKing
  • Comments: 0
Logitech Gamepad F310 Case Replacement

Difficulty

Easy

Steps

4

Time Required

10 minutes

Introduction

Use this guide to replace a damaged or cracked controller case on your Logitech Gamepad F310. The controller case is what holds your controller together. That is reason to replace controller case.

Follow this guide in order to replace your Logitech Gamepad F310 controller case.

No special tools or skills required.

  1. 5X4mDBDlm4aCpX1U
    5X4mDBDlm4aCpX1U
    ykdOIWy5uogN3YJL

    • Use a Phillips #1 screwdriver to remove all seven 3 mm screws that secure the rear case.

  2. ENHWNNOBAUMSMUUG
    ENHWNNOBAUMSMUUG
    VZVjqsEXtmDEFLfE

    • Press along the seams of the controller and gently pull the front and rear case apart.

    • If necessary, use an opening tool to help pry the front and rear case apart.

    • Make sure to open the controller with the front facing down so that the buttons do not fall out.

  3. pPS1JtQ3XEj1P4sw

    • Separate the front and rear case.

    • There are two side panels on the controller that come apart as well. When putting them back together, they slot into place on the sides of the controller.

  4. h2LoZpETS4njkcaV
    h2LoZpETS4njkcaV
    oZjsBkrJWHakyexl

    • Use a Phillips #1 screwdriver to remove:

    • Four 3 mm screws

    • One 5 mm screw

    • Remove the central silver screw last.

    • Gently lift the motherboard off of the back case and slide the cord out of the slot on top.

Conclusion

You have successfully taken the case off of your controller! Using the new case, follow these steps in reverse order to assemble your fixed controller.

Author

Alan Mendoza DracoKing

Member since: 05/02/24

169 Reputation

0 comments