KitchenAid Professional 600 Top Cover Replacement

Written By: Luke
  • Comments: 1
KitchenAid Professional 600 Top Cover Replacement

Difficulty

Moderate

Steps

3

Time Required

No estimate

Introduction

Outline what you are going to teach someone how to do.

  1. fbmOcR1Nv425QUqh

    • Take out the screw which holds on the silver band using a Phillips #2 screwdriver.

    • Remove the silver band.

    Maybe start with unplugging it ?

    Ryan F -

  2. ZCMIIPP1eoaPPXvx

    • Remove the four Phillips #2 screws located around the mixer where the band was removed.

    • This picture only shows two of the screw that you need to remove. The other two are on the exact opposite side of the mixer.

  3. HrJKZjfMarTMmBHX

    • Remove the top of the mixer to reveal the inner parts.

    • The top should lift off, but may not if it is stuck. A sharp strike from the back with the hand may unstick it. It will slide forward about a 3/8 of an inch. Push it back again from the front and it should be free enough to lift.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Luke

Member since: 11/04/16

1380 Reputation

0 comments