Jura Impressa S model backpanel

Written By: VauWeh

Comments: 2

Difficulty

Moderate

Steps

Time Required

No estimate

Introduction

If you want to gain access to inner parts (e.g. pump or heater), you have to remove the backpanel. It is secured by two proprietary screws with oval head.

Tools

Step 1

Always remove the power cord from the wall outlet.
Lift out the coffee tray
Remove the lid sealing the coffee bean container
Remove all of the coffee beans you can possibly remove.
Pull the adjuster of the coffee bean grinder straight up
Remove the four T15 Torx screws

With the Impressa XS 90 there is an additional ground beans funnel that needs to be removed that hides two of the four torx screws

Ian Channing -

Step 2

Remove the cup heat plate.
It can be opened like a book.
Below the cup heat plate there are three more T15 Torx screws. Remove them.

Step 3

The top cover is now free. Lift ´er up and set ´er aside.

With the Impressa XS 90 there is an additional cover above the grinder that has wires glued to it that prevents you from taking the top completely off.

Ian Channing -

Step 4

The backpanel is secured with two proprietary screws with oval head. They seem to be rivets, but in fact are screws. The only purpose is, to keep us out of our own devices. You can remove them using an oval drive bit. (Part of some IFixit tool collections or available at a Jura provider or iFixit). In a pitch try needle nose pliers. Here a DIY guide.
Remove the two oval head screws on the lower edge of the backpanel.
Lift the panel up.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

VauWeh

Member since: 19/10/15

234423 Reputation