Introduction
Dripping water out of the joint between water reservoir and machine is an annoying issue. The water reservoir seal should be replaced. This ist a very easy fix, you even need not open the Impressa.
Tools
Parts
-
-
Remove the water reservoir.
-
Turn the Jura on its side to have access to the bottom plate
-
The water connector is protected by a plastic cover, which is secured by two plastic rivets.
-
Use some pliers and squeeze the rivets tightly and push them up until they release.
-
Carefully pry up the plastic cover.
-
Insert the new gasket with the flat side facing up.
-
Give some food-proof lubricant to the new seal and replace it.
-
Conclusion
To reassemble your device, follow these steps in reverse order