Introduction
This guide will show the required steps to replace the ice tray on the Insignia Ice Maker.
-
-
Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required.
-
Disconnect the water tray cord.
-
To reassemble your device, follow these instructions in reverse order.
4 comments
Where do I find insignia ice maker ns- imp26ss7 replacement ice forming tray? Can't locate item on the internet.
I found a seller on ebay that has 7 of them and is selling them for $20 shipped
what is the proper sequence to time ice tray?? it fills now on empty cycle. If I play with the micro switch on the left of the tray and get the tray to stop at the proper position ,allow it to fill, it will finish that cycle, empty, and then go back to the empty position. [the ice tray] baffled!!! can you help??