Insignia Flex 10.1 NS-P16AT10 Camera Replacement

Written By: Morgan Kidd
  • Comments: 0
Insignia Flex 10.1 NS-P16AT10 Camera Replacement

Difficulty

Easy

Steps

5

Time Required

15 minutes

Introduction

This guide will show you how to replace the camera on your Insignia Flex 10.1 tablet.

  1. ofnpJSVsMNSULmq1
    ofnpJSVsMNSULmq1
    jbSbHWMymuiDhEDD

    • Make sure your device is off and not connected to any power sources to avoid injury

    • Use a plastic opening tool to remove the rear panel from the front case.

    • Insert the plastic opening tool between the front case and rear panel. Use a prying motion to lift the front case from the rear panel.

    • The volume rocker and power button will become free from the device when the front and rear panels are separated from each other. Do not worry. These pieces are easily put back into place when reassembling the tablet.

  2. csHhRg6JraK1D4aq
    csHhRg6JraK1D4aq
    hZa2lDwpQGvTyNic

    • Use a plastic opening tool to flip up the ribbon connector that connects the camera to the motherboard.

    • Free the ribbon cable from the motherboard.

  3. bBbPKyZ6XMmH6riP
    bBbPKyZ6XMmH6riP
    kZhSOT4WYxZFjlBv

    • Use a #00 Phillips head screw driver to remove the two screws that hold the camera down to the front case.

  4. dwAvISVENUWguh3I

    • Use tweezers or your fingers to remove the camera from your Insignia Flex 10.1 NS-P16AT10.

  5. 3MebnjUsgFLbRHX3
    3MebnjUsgFLbRHX3
    FthGrPoPU5KADJAU

    • The camera is now free and ready to be replaced.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Morgan Kidd

Member since: 10/10/16

419 Reputation

0 comments