Infinity Genesis hood Replacement

Written By: Nick
  • Comments: 0
Infinity Genesis hood Replacement

Difficulty

Moderate

Steps

7

Time Required

30 minutes

Introduction

  1. ArBAaxV5ktk2ARPy
    ArBAaxV5ktk2ARPy
    SCm5MIWavv4GnvXR
    eOaIo6vUAcLdr4OF

    • To begin remove Right and Left armrests . See assembly guide on how to remove these.

    • Unzip the following zipper at the very top of the chair. It is hidden beneath Velcro .

    • Leave back pad like this no need to unzip any other zippers.

  2. NThHIjJvrwW4sLUm
    NThHIjJvrwW4sLUm
    f6H2MXURJoSUYL1r
    ydTJbrpQkENiRGFM

    • Remove all 8 Screws on back cover.

    • End Result should like this .

  3. kPyDQ3TBHlUEiBKx
    kPyDQ3TBHlUEiBKx
    WgL1HUfJmnESZS4j

    • Remove Top 4 screws .

  4. rfZLaNIoWakTstMO
    rfZLaNIoWakTstMO
    RTCHlGucMAhHPpwb
    PScBujKtCSYqQMCn

    • You will need to disconnect the power cables on Left and Ride side of the hood assembly . They are attached via a clip. Simply push the clip down and pull them apart.

  5. E4h6o2PxuVMsUypj
    E4h6o2PxuVMsUypj
    2tgeFC2gjuQ1OIkE
    ZZ2ylKUcVdGp5nSE

    • You need to find the 6 way air valve on the left and right hand side.

    • You then need to Locate and remove the top air hose from the valve. You can usually identify this hose by the armor cover it has on it . Additionally its the only air hose that goes to the top.

  6. 5WTccPRDgDGD1TSJ
    5WTccPRDgDGD1TSJ
    TOOyPoyQHVKu2iWk

    • BEFORE CONTINUING DOUBLE CHECK YOU HAVE DONE THE PREVIOUS STEPS TO ENSURE EVERYTHING HAS BEEN DISCONNECTED .

    • To remove the hood piece lift upwards to slide it off of the Frame points.

    • Marked here are the 4 frame points . Remember where these are for re- assembly.

    • See last photo for end result.

  7. JiAbIiSyWSKKoZ4L
    JiAbIiSyWSKKoZ4L
    5UyvQXO4RaF1pUT1

    • For reassembly of back panel Please be sure to lock in these Ball and Joint pieces into each other . They are located at the top of the chair.

    • If you don't lock these in first you will have a harder time securing this panel back on . Additionally once these Ball and joint pieces are connected. Secure the middle screws on the cover first this will ensure the cover will line up with the other bolts.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nick

Member since: 30/05/17

2737 Reputation

0 comments