Introduction

Prerequisite only! Use this guide to disconnect the battery assembly in your Huawei Watch GT 2 (46 mm).

  1. ilVxkpVKgnI2Ev5G
    • Before starting repairs, take your watch off the charger and power it down.

    • Remove the watch band.

    Meine Uhr läßt Sicht nicht ausschalten und reseten.

    Chris G -

  2. iqQMELJhICcegBUY
    • Remove the four 3.7 mm-long Torx T2 screws.

  3. V5XxdHQuZTVHMMMR
    V5XxdHQuZTVHMMMR
    3QZLp2OxOsOiJCBt
    • Insert the edge of a spudger into the middle loudspeaker opening at the top edge of your watch.

  4. XlCRrBMNGKgH2RaQ
    XlCRrBMNGKgH2RaQ
    dJGSvCUKHPBwBEkR
    • The plastic clamps holding the back cover in place sit very tight and may require some force during the prying procedure.

    • Use the spudger to pry up the back cover assembly of your Huawei watch GT 2.

    • Don't try to remove the back cover assembly all the way yet, it's still connected to the motherboard.

  5. DMO5iwerreCkJ63l
    DMO5iwerreCkJ63l
    nNnXovmc2KQN2EYv
    • Carefully swing the back cover assembly open to an upward position.

    Muchas gracias, ha sido muy útil esta guía.

    Ricardo Seiffert -

  6. Z2OCOWPr2S6GIRNV
    • Remove the two 2.3 mm-long Phillips #00 screws.

  7. QuUnxlir5E1TMHEJ
    QuUnxlir5E1TMHEJ
    ap2OgASgpXgKm6tN
    • Use a pair of tweezer to remove the metal shield covering the multi-purpose flex connector.

  8. UjBDIxT1PbmCLVMY
    UjBDIxT1PbmCLVMY
    o6JqlZPhGtkJnhvp
    • Use the flat end of a spudger to pry up and disconnect the multi-purpose flex connector.

  9. ISeGjiIVBKM1iOAO
    • Separate the back cover assembly from the watch case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Dominik Schnabelrauch

Member since: 23/11/16

224668 Reputation

0 comments