How to Prepare the Barreto Trencher E718MTH4S 2016 for Service

Written By: Adam O'Camb
  • Comments: 2
How to Prepare the Barreto Trencher E718MTH4S 2016 for Service

Difficulty

Moderate

Steps

1

Time Required

No estimate

Introduction

Prerequisite-only guide to make sure the Barreto Trencher E718MTH4S 2016 is off and immobilized prior to servicing.

  1. qdSV6unHOFIr4OIg
    qdSV6unHOFIr4OIg
    i1sBdtWuGTJK6jEg
    cnvrE3AsrUJFLjNL

    • Make sure that both ignition switches are turned to the off position. There is one on the engine and one on the control panel.

    • Pull the ring near one of the wheel hubs straight out, away from the wheel.

    • Rotate it so that the small roll pin lines up with its slot.

    • Release the ring so that the lock pin slides into the wheel. You may need to rotate the wheels a little before the lock pin fully engages.

    • With the pin engaged, it should be very hard to turn the wheels.

    • Repeat this step so that the lock pins on both wheels are engaged.

    Why 10311 for the chain roller assembly? It doesn't include the bearings. Part number 00265 includes the bearings.

    JAMES -

    It's also important to ensure that the boom cushion washer is still between the tension bolt and the boom cushion. Mine was missing and the tension bolt was screwed all of the way in, which took it halfway through the boom cushion, which resulted in a chain that was too loose.

    JAMES -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Adam O'Camb

Member since: 11/04/15

206065 Reputation

0 comments