Honda Rear Tine Tiller FRC800K1A Outer Belt Cover Replacement

Written By: Carsten Frauenheim
  • Comments: 0
Honda Rear Tine Tiller FRC800K1A Outer Belt Cover Replacement

Difficulty

Moderate

Steps

4

Time Required

No estimate

Introduction

Prerequisite only! This guide shows how to remove and replace the outer belt cover in a Honda FRC800K1A Rear Tine Tiller.

  1. W64s14UYWLflrhJu
    W64s14UYWLflrhJu
    VR5CMjfaIqSoDspN

    • Before you begin the repair, disconnect the spark plug wire.

    • Firmly grip the base of the connector and pull it away from the spark plug to disconnect it.

  2. KesuYQwmhQaDFSKY

    • Flip the fuel valve switch to the off position.

  3. Jo3621gfqkErQmHr

    • Use a 14 mm socket to remove the bolt securing the outer belt cover.

  4. Ho1bStsBJmWDyUWt
    Ho1bStsBJmWDyUWt
    hfDvvQNNhweqRRNt
    4vAZ5wT4FSa4FnWN

    • Tilt the outer belt cover down and pull it off of the lip on the inner belt cover to remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Carsten Frauenheim

Member since: 10/03/20

130781 Reputation

0 comments