Introduction
Tools
-
-
Open the Visor Edge placing the screen and the inner part of the flip cover face down on a flat surface such as a table
-
On the back of the PDA there is a tab connecting the flip cover to the device. Push gently on this tab trying to slide the cover upwards along the surface then lift the pieces apart to fully detach them
-
-
-
To reassemble push the downward on the flip cover where there is an indent on the PDA indicating where the pieces connect
-
Finish by pushing the cover until it snaps in to place
-
-
-
Once flip cover is removed, turn over and remove the four 3.9 mm screws connecting the hinge.
-
-
-
Turn the hinge piece on its side or use a screwdriver to pull out the spring.
-
Reinsert new spring.
-
To reassemble your device, follow these instructions in reverse order.
